EN 10025 S420M flaw detection process

S355J2 steel plate rolling process is controlled rolling process. In the rolling process, the ingot rolling temperature is 1000-1050℃; in the first stage, the low-speed and large reduction rolling process is adopted, the high-temperature stage is 950-1000℃, the EN 10025 S420M rolling speed is 1.6-2.0m/s, the single reduction rate is 15-20%, and the cumulative reduction rate is 40-45%, so as to ensure sufficient deformation of ingot. In the first stage, the start rolling temperature is 910-930℃, and the finish rolling temperature is ≤ 870℃.As a basic building material, steel plates are currently widely used in automobiles, shipbuilding, chemical industry, aerospace and other fields. Reasonable selection of flaw detection methods to ensure the quality of EN 10025 S420M steel plates is of great significance to safe production. Common defects of steel plates are folding, inclusion, shrinkage, air bubbles, delamination and cracks. These problems can be discovered in time through flaw detection.

EN10025-2 S235J2 steel is equivalent to our Chinese teel grade Q235D. They are both done low temperature impact test at -20℃. Sometimes S235J2 would be used to built containers which can bear low temperature sea water. EN 10025 S420M, S235J2+N steel plate, following a rolling process within a certain temperature range, producing a material in a condition equivalent to that obtained after normalization. With the result that the specified mechanical properties values are conserved even after normalization treatment.

Our quality control department will do inspection for details of the steel materials EN 10025 S420M before delivery. We would invite the customer side to attend the inspection together. If they can not come, we will also take rich pictures for them to check. Meanwhile, we will publish inspection report and send them the PDF version. Besides, we accept any third party inspection such as SGS, BV, etc. And our quality control department will support the third party to inspect the steel materials smoothly and try our best to deliver the qualified steel materials to customers earlier.

Our quality and service commitment: EN 10025 S420M product quality problems, life-long replacement.In the process of using, any time if you find we supplied steel materials not conform to the requirements of technical standards, we can replace it for you free of charge. However, it should be noted that non product quality problems caused by improper use are not covered by the warranty. Please pay attention to the service time commitment as well as the product quality assurance commitment. Because only the products of big brands and reliable enterprises with complete after-sales service system can truly realize the long-term product quality assurance and the whole process of service.

The company always adheres to the concept of green production, follows the development path of innovation, transformation and improvement, and has carried out in-depth cooperation with Zhengzhou University and other scientific research institutes, planning from a high starting point, strict standard design, and successfully implementing engineering projects With nearly 20 research and development projects, the company's production technology and equipment are at the forefront of the industry, and indicators such as environmental protection, energy consumption, cost, and resource utilization have reached the advanced level in the industry.

The strip steel thickness is generally below 6mm, which is convenient for crimping and processing. You should choose the EN 10025 S420M, strip steel specifications according to your own purposes. The specifications and materials used for different purposes are different, so you must confirm it before buying. It is best to ask professionals to give advice before purchasing strip steel, and purchase the specifications and types you need according to the corresponding requirements.