Welcome to Henan BBN Steel

  • zhengzhou
    henan ,China
  • Opening Time
    Mon - Sat: 08.00 to 18.00
Pageviews:

The effect of nitrogen (N) on the properties of S420ML steel properties and so on steel is similar to that of carbon and phosphorus. With the increase of nitrogen content, the strength of steel can be significantly improved, especially the plasticity, especially toughness, and the weldability will be decreased, and the cold brittleness will be intensified. At the same time, aging tendency, cold brittleness and hot brittleness will be increased, which will damage the weldability and cold bending property of steel. Therefore, the nitrogen content in S420ML steel properties and so on steel should be reduced and limited as much as possible. Generally, nitrogen content should not be higher than 0.018%.

The development of modern high-strength steel, S420ML steel properties is a process of gradually reducing the carbon content. The reduction of carbon content is beneficial to increase the toughness of steel on the one hand, and can significantly improve the welding performance of steel on the other hand. For large-scale steel structural parts with complex forces that require higher toughness and welding performance, a carbon content design of ≤0.10% is usually adopted.

Since 2020, the foreign trade industry has been significantly affected by the epidemic. In the first two months of this year, China's S420ML steel properties and so on steel exports totaled 7.811 million tons, down 27% year-on-year, the largest decline since March 2018. In terms of steel foreign trade, China is mainly a steel exporting country, with less steel imports.

Structural steel is a category of steel construction material that is produced with a particular cross section or shape, and some specified values of strength and chemical composition. S420ML steel properties, Structural steel plates are normally supplied in the as-rolled condition. Our structural steel plate are supplied with thickness range 3mm to 350mm. The plates may be ordered normalized or stress relieved, or both. steel plates shall be normalized. steel plates and sheets shall be quenched and tempered.

Previous:S355nl VS S355ML stock resources Next:EN10025-4 steel S460ML manufacturer in C

Add Your Comments

First Name*

Tel*

Email*

Your Comments*