-
zhengzhou
henan ,China
-
Opening Time
Mon - Sat: 08.00 to 18.00
-
Mail Us
[email protected]
How to prevent EN 10025 S355 ml, steel plate cutting cracks? 1. Preheat the steel plate before cutting, and the preheating temperature depends on the quality grade and thickness of the steel plate. However, it needs to be heated evenly. 2. The cutting speed is reduced appropriately, but its reliability is not as good as preheating. It is suggested to preheat the cutting belt with flame gun cavitation several times before cutting, and the preheating temperature should reach about 180℃.
A588 Grade A steel plate is for high strength low alloy structural steel with 345Mpa minimum yield point to 100mm thickness."When propertly exposed to the atmosphere, A588 Grade A is suitable for many applications in the bare condition. EN 10025 S355 ml, A588 Grade Acould be produced in 200mm in our company.
EN 10025 S355 ml, Special thick steel plate cutting needs to be preheated in advance. Some steel plates are prone to cracks after entering the cutting process, sometimes that is because the temperature is too low, and it is necessary to perform pre-heat treatment in advance for such cases. The staff can preheat the steel plates first, so that the temperature of the steel plates will gradually increase, and then the flame gun can be used to cut. The probability of cracks in the cut material is very low, and the quality of the steel plate is also guaranteed.
During the construction of hot-dip EN 10025 S355 ml galvanized pipe, the correct welding process shall be adopted, the inspection and acceptance shall be carried out in strict accordance with the specification, and the anti-corrosion treatment (zinc rich paint) shall be done timely after the welding is completed. It is feasible in the construction process of open and closed air conditioning system, which can improve the EN 10025 S355 ml construction speed and the firmness of the pipe connection. Therefore, the hot-dip galvanized pipe can be welded and connected under the construction conditions and on the premise of relevant protection and anti-corrosion measures.
