The selection principle of steel plate for high-rise building is: it can not only make the structure safe and reliable, but also can save steel and reduce the cost. Different use conditions should have different quality requirements. In terms of the mechanical properties of steel such as acero S355M, yield point, tensile strength, elongation, cold bending property, impact toughness etc. are the indicators to measure the quality of steel. In the design of steel structure, the appropriate steel should be selected according to the characteristics of the structure. The selection of steel is not only an economic problem, but also related to the safety and service life of the structure.
GB / T1591 Q345D steel is a commonly used low alloy plate in China. It is equivalent to grade S355J2 in Germany and ASTM A529MGr50 in the United States, with slightly different chemical composition and the same mechanical properties. Under normal delivery conditions, acero S355M, Q345D steel equivalent to S355J2G3 in European standard, and even almost the same performance as the S355J2G4. They can be used interchangeably.
Based on the main acero S355M business of iron and steel, we are committed to producing high-quality, green and efficient steel products. The main steel products are medium and heavy plate, hot rolled coil, section steel, steel tube, etc., which are widely used in automobile, oil, railway, bridge, construction, electricity, transportation, machinery, shipbuilding and other important fields. Our steel acero S355M products are exported to Indonesia, Bangladesh, Myanmar, Iran, Brazil, Mexico, UAE, Iraq, etc Egypt, Mozambique, Ukraine and other dozens of countries and regions.
The effect of nitrogen (N) on the properties of acero S355M and so on steel is similar to that of carbon and phosphorus. With the increase of nitrogen content, the strength of steel can be significantly improved, especially the plasticity, especially toughness, and the weldability will be decreased, and the cold brittleness will be intensified. At the same time, aging tendency, cold brittleness and hot brittleness will be increased, which will damage the weldability and cold bending property of steel. Therefore, the nitrogen content in acero S355M and so on steel should be reduced and limited as much as possible. Generally, nitrogen content should not be higher than 0.018%.